Skip to content

B2013

No End-of-Line Programming

Possible Causes

  • Control Module replaced (with NEW Control Module)
  • Control Module reset
  • Dataset Missing

Possible Solutions

  • Perform End-of-Line Programming
  • An online connection with the manufacture is required for Parameterization via the SVM.

Special Notes

  • Parameterization refers to data written into the control unit by the SVM function (Software Version Management) to customize the software functionality for the specific vehicle or country of operation.

  • Often referred to as the “calibration data”, it is necessary Parameterization is performed anytime there is missing or invalid data-set fault codes and/or it is suggested by SVM test plan to ensure the proper functionality of the control unit.

  • Not all control units are parameterized by SVM.
  • Parameterization MUST BE PERFORMED to ensure the control unit will function properly in the vehicle!
  • When found in the 34-Level Control (J197) module on (4H/4G) chassis Audi A6, A7 and A8 models Coding and Suspension Calibration will not be possible using VCDS until the module is reconfigured using [[Official Factory Repair Information|ODIS]]. This thread includes warnings related to that DTC in addition to the calibration steps when the module has not lost EOL Programming: [https://forums.ross-tech.com/showthread.php?12737-UDS-Re-adapt-Adaptive-Suspension-to-default-position UDS - Re-adapt Adaptive Suspension to default position ]